AirTAC SDA16x5B – Compact Square Pneumatic Cylinder Bore 16 × Stroke 5mm
Looking for an ultra-slim, short-stroke compact square pneumatic cylinder equipped with a male-threaded piston rod for direct linkage connection? The AirTAC SDA16x5B belongs to the standard SDA compact cylinder series by AirTAC. It features a 16mm bore, 5mm stroke, double-acting operation, and a male-threaded piston rod (B).
Key Features of AirTAC SDA16x5B
✅ Ultra-slim compact square pneumatic cylinder (SDA series – Standard Double Acting).
✅ Bore: 16 mm.
✅ Stroke: 5 mm.
✅ Action: Double acting.
✅ Piston rod end: Standard male thread M5×0.8 (B suffix – includes hex lock nut).
✅ Non-magnetic piston (standard version; choose AirTAC SDA16x5SB if magnetic sensor mounting is required).
✅ Hard-anodized aluminum alloy tie-rodless body saves installation space while offering high wear and corrosion resistance.
✅ Built-in sensor grooves around the body and rubber bumper pads at both ends ensure quiet, reliable operation.

Technical Specifications
✅ Model: SDA16x5B (SDA16X5B)
✅ Series: SDA (Compact Cylinder – Standard Double Acting)
✅ Bore: 16 mm
✅ Stroke: 5 mm
✅ Rod diameter: 6 mm
✅ Rod end type: Male thread M5×0.8 (B suffix)
✅ Action: Double acting
✅ Cushioning: NBR rubber bumper pads at both ends
✅ Magnet: No (select S suffix for magnetic piston)
✅ Operating pressure: 0.15 – 1.0 MPa (22 ~ 145 psi)
✅ Proof pressure: 1.5 MPa (215 psi)
✅ Piston speed: 30 – 500 mm/s
✅ Operating temperature: -20°C ~ +70°C
✅ Port size: M5 × 0.8
✅ Fluid: Air (filtered by 40μm filter element)
Typical Applications
✅ Ultra-short stroke (5mm) pushing, diverting, stopping, and positioning mechanisms in tight spaces
✅ Electronics, PCB, semiconductor, and automated medical device assembly machinery
✅ Small workpiece clamping jigs in precision machining fixtures
✅ Direct connection to clevis joints (Y-joint), knuckle joints (I-joint), or custom fixtures via the M5×0.8 male rod thread
✅ High-speed packaging, labeling, filling, and automated sorting lines
Why Choose the AirTAC SDA16x5B?
The AirTAC SDA16x5B pairs a space-saving square aluminum housing with a ready-to-connect B-code male rod thread, eliminating the need for extra thread adapters. Its heterogeneous two-way piston seal with grease retention extends service life and ensures smooth, low-maintenance performance.
Selection & Installation Tips
✅ Confirm 16mm bore, 5mm stroke, and M5×0.8 male rod thread (B suffix) match your mechanical linkage requirements.
✅ Note that SDA16x5B is non-magnetic; select AirTAC SDA16x5SB if magnetic stroke-end sensing is needed.
✅ Supply clean compressed air filtered to 40μm or finer to protect internal piston seals.
✅ Use M5×0.8 pneumatic fittings with sealing washers for the air ports and avoid radial side loads on the 6mm piston rod.
Hotline: 0084 787900099